What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
09.06.2025 08:57

This device then solves the entire problem.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
The World Ends with You Director Tatsuya Kando Leaves Square Enix - Anime News Network
The bolt then partially travels down the line to your home.
eight
He then describes Rainy Season and Lightning.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
He then describes the function of a fuse.
In schematic diagrams this is the symbol for a fuse:
A rocket scientist wrestles with backlash over her Blue Origin flight - The Washington Post
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
nine
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
A fuse is a non-resetable over current circuit protector.
Barnstars:
One
[image of Common-mode choke]
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
It also is a device that limits the change in current flow.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This is 'the assistant's answer'
So, the voltage could go up to 500 volts, and the fuse will not open up.
5 Things to Know Before the Stock Market Opens - Investopedia
This is where the MOV conducts again, and dissipated the energy.
First Sentence:
What does a fuse do?
Main Card Results | UFC 316: Dvalishvili vs O'Malley 2 - UFC.com
The MOV will conduct when the voltage exceeds 50% of line voltage.
He then asserts :
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
$200 for a Refurbished MacBook Air Is a Tough Deal to Beat - PCMag
what exactly is a ‘surge’ protector?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
But… the neutral is now “floating” because of the 1 ohm resistance.
A circuit breaker is similar, but is resettable.
This one hit behind the barn.
(Dc diagram shown, AC is similar).
2024–10–16 [ OO OLAOYE OYEBODE ]
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
the problem then depends on "how fast does the fuse operate?".
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
These are simplified answers to the original question, and does not change anything I wrote above.
Upvotes:
a photo is worth a thousand words.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
These devices are installed between the “hot” and “neutral” and protective ground.
2024–10–10[John johnson John Johnson ]
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
2024–10–14 [Omar Gharbi Omar Gharbi ]
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
but I think this circuit , shows a few more pieces.
But it can get overloaded, and no longer works.
There are two important concepts here.
What is lightning?
Because the load is inductive, the current lags the voltage.(by a bit).
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
An AC voltage/ current source, and an ac inductive load.
There are three different concepts here that are getting confused.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
At least they know the answer if they wanted it.
[old diagram got deleted by accident]
so, what happens?
At one ohm, the resistor has a maximum of 1 watt power.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
One is “what exactly is in a ‘surge protector’ ? ”
For this case there are devices called Metal oxide varistors (MOV).
It seems Mohan does not understand the difference between a comment and an Answer.
The other is “what does a “fuse” do?”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is where this question deviates from being a 'generic' question, and becomes more specific.
Here is a simplified AC power diagram.
Now when you have a certain ac resistance, then a current flows in a loop.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
The third is lightning and “how it gets conducted into a home.”
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
but this device (an Inductor) … impedes the rapid changes in the current.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
I post the exact comment here.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Edit 2024–10.